Vibeleaderboard
Index / tool

NESH: The New EFI Shell

nesh.nicfio.it
Visit nesh.nicfio.it
Category
Developer Tools
Rank
No. 3035Tools index

Previous survey · No. 2820 ·

Pricing
Free
Type
TOOL
Latest release
v0.3.0
Date

About

NESH is a command shell for UEFI firmware, shipped as a single file (nesh.efi, about 363 KB) that needs no installation and only one signature for Secure Boot. It rewrites the UEFI Shell command set from scratch with more than 80 commands and adds NESH BASIC, a scripting language with over 50 built-in functions, to replace .nsh scripts. Low-level hardware writes are disabled while Secure Boot is active.

At a glance

NESH is a UEFI command shell with a BASIC-like scripting language. It is worth exploring when you need repeatable inspection of firmware, disks or boot entries before the operating system starts.

Good fit

Firmware enthusiasts and administrators rehearsing pre-boot diagnostics in a virtual machine.

Consider something else when

Pass if the system already boots and ordinary operating-system tools can answer your question, or if your use falls outside the published license.

Start here

Start in a disposable UEFI virtual machine and write a read-only script that lists volumes. Check its output before considering any command that changes boot entries.

Cost and requirements

The source uses the PolyForm Noncommercial license. It runs as an EFI executable, and Secure Boot requires an appropriate signature or trust setup.

Limits to know

Firmware commands can change boot configuration or storage. Test against disposable virtual disks and keep the first workflow read-only.

Tags

uefishellfirmwarebasicscriptingsecure-boot

Media

NESH: The New EFI Shell

Comments (0)

No comments yet

Editorially curated, with community endorsements as a secondary signal. Corrections welcome.